- ページ 11

溶接アクセサリー Miller RUNNING GEARのPDF 取扱説明書をオンラインで閲覧またはダウンロードできます。Miller RUNNING GEAR 22 ページ。

SET-UP & ASSEMBLY

CAUTION

Handle the component assemblies carefully to avoid injury; they are very heavy

and awkward.

NOTE: Use a lift truck or overhead hoist to aid in the handling the heavy compo-

nents. Before proceeding, have the tires mounted on the wheels and know what

the required reach and bolster settings should be.

CAUTION

If running gear is ordered without mounted tires, it is recommended that tire

mounting only be attempted by a qualified tire manufacturer's installer or properly

trained personnel according to the manufacturer's instructions.

REAR AXLE

Couple the rear axle assembly to the reach pole with the (4) 5/8" x 1-1/2" Gr.5

bolts, (8) 5/8 dia. flatwashers, HT and (4) nylon insert lock nuts. Torque to 110

ft. lbs.

FRONT AXLE

Couple the front axle assembly to the reach pole with the (4) 5/8" x 1-1/2" Gr.5

bolts, (8) 5/8 dia. flatwashers, Ht and (4) nylon insert lock nuts. Torque to 110 ft.

lbs.

Safely raise and properly support the assembled axles and reach pole and

proceed to securely fasten the wheel and tires to the hubs with the (6 or 8) wheel

nuts torqued from 90 to 105 ft-lb.

NOTE: Flanged style wheel nuts are ONLY to be used with flat dish style wheels

(4.25 x 22.5 Tires).

CAUTION: DO NOT use flanged style wheel nuts with formed dish style wheels.