Miller RUNNING GEAR Manual do operador - Página 11

Procurar online ou descarregar pdf Manual do operador para Acessórios de soldadura Miller RUNNING GEAR. Miller RUNNING GEAR 22 páginas.

Miller RUNNING GEAR Manual do operador
SET-UP & ASSEMBLY
CAUTION
Handle the component assemblies carefully to avoid injury; they are very heavy
and awkward.
NOTE: Use a lift truck or overhead hoist to aid in the handling the heavy compo-
nents. Before proceeding, have the tires mounted on the wheels and know what
the required reach and bolster settings should be.
CAUTION
If running gear is ordered without mounted tires, it is recommended that tire
mounting only be attempted by a qualified tire manufacturer's installer or properly
trained personnel according to the manufacturer's instructions.
REAR AXLE
Couple the rear axle assembly to the reach pole with the (4) 5/8" x 1-1/2" Gr.5
bolts, (8) 5/8 dia. flatwashers, HT and (4) nylon insert lock nuts. Torque to 110
ft. lbs.
FRONT AXLE
Couple the front axle assembly to the reach pole with the (4) 5/8" x 1-1/2" Gr.5
bolts, (8) 5/8 dia. flatwashers, Ht and (4) nylon insert lock nuts. Torque to 110 ft.
lbs.
Safely raise and properly support the assembled axles and reach pole and
proceed to securely fasten the wheel and tires to the hubs with the (6 or 8) wheel
nuts torqued from 90 to 105 ft-lb.
NOTE: Flanged style wheel nuts are ONLY to be used with flat dish style wheels
(4.25 x 22.5 Tires).
CAUTION: DO NOT use flanged style wheel nuts with formed dish style wheels.
7