- ページ 19

溶接アクセサリー Miller T94i SeriesのPDF オーナーズマニュアルをオンラインで閲覧またはダウンロードできます。Miller T94i Series 40 ページ。 Auto-darkening helmets
Miller T94i Series にも：マニュアル (32 ページ)

ページを印刷する

5-7.

Sensitivity Control

1 Mode Button

2 Adjust Button

3 Increase (+) And Decrease (-) Buttons

Use control to make the lens more respon-

sive to different light levels in various welding

processes. Use a Mid-Range or 30-50% sen-

sitivity setting for most applications.

It may be necessary to adjust helmet sensi-

tivity to accommodate different lighting condi-

tions or if lens is flashing On and Off.

The sensitivity ranges for each mode are as

follows:

Weld, Cut, X-Modes - 0 - 10

Grind Mode - No sensitivity adjustment

Do not weld in the Grind mode; the

lens will not darken.

Sensitivity Adjustment Procedure

Stick Electrode

Short Circuiting (MIG)

Pulsed And Spray (MIG)

Gas Tungsten Arc (TIG)

Plasma Arc Cutting/Welding

(R)

MEMO ( B )

Recommended Sensitivity Settings

�

Adjust helmet sensitivity in lighting con-

ditions helmet will be used in.

� Press Mode (On/Off) button to turn lens

On. Helmet control display will appear.

� Press Mode button to select desired

function: Weld, Cut, or X-Mode.

� Use the Adjust button to select sensitiv-

ity, then use the +/- buttons to adjust

sensitivity to the lowest setting.

� Face the helmet in the direction of use,

exposing it to the surrounding light

conditions.

� Press + button until the lens darkens,

then press - button until lens clears.

Helmet is ready for use. Slight readjustment

may be necessary for certain applications or

if lens is flashing on and off.

�

Reduce Sensitivity setting if lens stays

dark longer than Delay setting.

Mid-Range

Low/Mid-Range

Mid-Range

Mid/High-Range

Low/Mid-Range

OM-255503 Page 17