Miller T94i Series Посібник користувача - Сторінка 19
Переглянути онлайн або завантажити pdf Посібник користувача для Зварювальне приладдя Miller T94i Series. Miller T94i Series 40 сторінок. Auto-darkening helmets
Також для Miller T94i Series: Посібник (32 сторінок)
Друкувати сторінку
5-7.
Sensitivity Control
1
1 Mode Button
2 Adjust Button
3 Increase (+) And Decrease (-) Buttons
Use control to make the lens more respon-
sive to different light levels in various welding
processes. Use a Mid-Range or 30-50% sen-
sitivity setting for most applications.
It may be necessary to adjust helmet sensi-
tivity to accommodate different lighting condi-
tions or if lens is flashing On and Off.
The sensitivity ranges for each mode are as
follows:
Weld, Cut, X-Modes - 0 - 10
Grind Mode - No sensitivity adjustment
Do not weld in the Grind mode; the
lens will not darken.
Sensitivity Adjustment Procedure
Stick Electrode
Short Circuiting (MIG)
Pulsed And Spray (MIG)
Gas Tungsten Arc (TIG)
Plasma Arc Cutting/Welding
(R)
MEMO ( B )
Recommended Sensitivity Settings
1
2
2
�
Adjust helmet sensitivity in lighting con-
ditions helmet will be used in.
� Press Mode (On/Off) button to turn lens
On. Helmet control display will appear.
� Press Mode button to select desired
function: Weld, Cut, or X-Mode.
� Use the Adjust button to select sensitiv-
ity, then use the +/- buttons to adjust
sensitivity to the lowest setting.
� Face the helmet in the direction of use,
exposing it to the surrounding light
conditions.
� Press + button until the lens darkens,
then press - button until lens clears.
Helmet is ready for use. Slight readjustment
may be necessary for certain applications or
if lens is flashing on and off.
�
Reduce Sensitivity setting if lens stays
dark longer than Delay setting.
Mid-Range
Low/Mid-Range
Mid-Range
Mid/High-Range
Low/Mid-Range
3
OM-255503 Page 17