- ページ 7

カメラアクセサリー Miller 1014のPDF 取扱説明書をオンラインで閲覧またはダウンロードできます。Miller 1014 12 ページ。 Arrow series fluid head with euro camera platform

CAMERA PLATE

CENTRE AXIS

FIG 4

2 MOUNT YOUR CAMERA

Arrow is equipped with a sliding platform for balance fine

tuning, plus a quick-release camera plate and standard camera

mounting screws (Arrow and Arrow 30 have 70mm sliding

range, Arrow HD has 100mm sliding range). Please note that

best camera control can be achieved by balancing the camera

centre of gravity (C of G) over the centre axis of the head.

2.1 Lock the PAN and TILT LOCKS (rotate both levers clockwise

2.2 Remove the CAMERA PLATE by pulling downwards on the

2.3 With accessories and battery fitted, determine your

2.4 Attach the CAMERA PLATE over the C of G by fastening

SLIDING PLATFORM

until firm).

SAFETY TAB while rotating the QUICK RELEASE to the left

until it reaches the automatic stop position (the CAMERA

PLATE will pop up).

camera's C of G by the best method available (Eg: balance

the camera on a rod or similar to find balance point).

the 3/8" + 1/4" CAMERA SCREWS into your camera's base

or 'tripod adaptor plate'. These screws should be

tightened evenly and as far apart as possible to prevent

any movement between your camera and the fluid head.

N.B. Arrow 30 is also supplied with a 1/4" screw & pin

carriage (Cat#493) for direct attachment to MiniDV

camcorders which do not require a tripod adaptor plate.

When attaching the camera carriage to a camcorder,

ensure the carriage's locating pin fits comfortably into the

camcorder socket, then screw the 1/4" screw clockwise

until the camera plate is attached firmly to the camcorder.

Warning: If the carriage pin does not easily fit into the

camcorder socket, DO NOT force it. Contact Miller or your

nearest authorised dealer for specific advice relating to

your camcorder model.