- ページ 4

浄水器 AQUAPHOR EXTRA-SOFTのPDF マニュアルをオンラインで閲覧またはダウンロードできます。AQUAPHOR EXTRA-SOFT 12 ページ。

ページを印刷する

4. The device and the principle of operation

Main parts:

1-Body

2-Preliminary treatment unit

3-Final treatment unit

1) The body of the water purifier (1) consists of an upper plate in which two collectors

are fixed to connect the exchangeable filter modules. The top plate is covered with a

decorative cover, fixed with three plastic clips. The main part of the body is a replaceable tank

with replaceable backfill.

2) The pre-filtration unit (2) includes a plug-in filter cartridge K5.

3) The post-filtration module K7 is included in the final water treatment unit.

How does the water purifier work?

From the cold water supply network water enters the inlet of the water purifier and passes

through the preliminary water treatment unit. Further, through a non-return valve, water enters

the tank with a replaceable backfill. Softened water passes through the final water treatment

unit and further to the consumer.

Installation

ATTENTION! Installation of the

water purifier must be carried

out only by persons,

authorized to carry out this

type of work.

Determine the convenient location

of the water purifier. In this case,

pay attention to the fact that the

supply tubes pass freely, without

kinks and folds.

The water purifier should be

installed on a flat, hard surface; be

distanced or isolated from sources

of heat (cookers, boilers, hot

water pipes, dishwashers or

washing machines, etc.).

6. Starting

Before using the water purifier, it is necessary to wash it. Connect the supply pipes and perform the washing procedure of the

modules.

Step 1

Connect the supply pipes following the diagrams below.

Connecting the JG pipes

Pull the locking clip (2) out of the plastic bushing (1) and

insert the pre-moistened end of the tube (3) into the sleeve

bushing to the stop at approximately 15 mm depth and set

the clip (2) in place. Check the strength of the tube fixation

(3): at an effort of 8-10 kg the tube should not be pulled

out.

К5

К7

How to disconnect the JG tubes

Pull the locking clip (2) out from under the plastic sleeve

(1) and pull the tube (3) by pressing the end of the plastic

sleeve. For pressing, use the wrench (4) to disconnect the

pipes included in the water purifier kit.

Fig. 1

inlet

outlet

Fig. 2