- ページ 9

浄水器 AQUAPHOR RO-202SのPDF 操作マニュアルをオンラインで閲覧またはダウンロードできます。AQUAPHOR RO-202S 16 ページ。 Reverse osmosis system

ページを印刷する

ATTENTION! If leaks are found, immediately

turn the inlet cock of the connecting assembly

to its closed position and check the connections.

Turn the inlet cock of the connecting assembly to

its open position again to continue the flushing

procedure after the leak is repaired.

• After the flushing procedure is complete, your

RO-202S beeps 5 times and switches into the

operating mode automatically.

• Turn the inlet cock of the connecting assembly

to its closed position and wait when the

cartridge life light and sound indication turns off.

Step 4. Flushing the reverse osmosis

membrane unit

• Remove the service plug from the slot of the

reverse osmosis membrane unit and replace it

with the membrane cartridge as shown in Fig. 1

• Turn the inlet cock of the connecting assembly

to its open position. The cartridge life indicator

lights blink (the light signal is be followed by

an audible one).

• Make sure the RO-202S connections are tight.

Attention! If leaks are found, immediately turn

the inlet cock of the connecting assembly to its

closed position and check the connections. Turn

the inlet cock of the connecting assembly to its

open position again to continue the flushing

procedure after the leak is repaired.

• Wait for the water to flow from the tap for treated

water.

• Let the water through your RO-202S for 1 hour.*

• Close the treated water tap.

Step 5. Flushing the water

conditioning unit

• Fill the storage tank with water (the light and

sound indication turns off), open the tap for

treated water and wait when all the water has

drained from the storage tank (a weak water

flow from the tap).

• Close the treated water tap.

• Fill and empty the storage tank 2 more times.

• Press and hold the PUSH button for at least

7 seconds. The cartridge life light indication

changes from the flashing mode to the constant

one, and the audio signal stops.

• Make sure the RO-202S connections are tight.

* The whole flushing procedure of the membrane cartridge takes no more than 24 hours and depends on its storage and transpor-

tation conditions.

Fig. 13

Membrane

cartridge

Fig. 14

• Your RO-202S is ready for use once the tank

is filled.

ATTENTION! The water is not intended for drink-

ing after flushing.

Periodically check your RO-202S for leaks during

the first week of use.

Some noise may occur during the first week of

operation of your RO-202S when switching the

valve because of air released from the internal

cavities of the system. This is not a malfunction.