- ページ 10

ウォーター・ディスペンサー Aquaport AQP-20SILのPDF 据付・取扱説明書をオンラインで閲覧またはダウンロードできます。Aquaport AQP-20SIL 16 ページ。 Signature filtered water cooler

D. SANITATION

WARNING: Turn off power and unplug unit before cleaning. It is

recommended the unit is disassembled and cleaned periodically.

Filter cartridge should be replaced every 600 litres or 6 months,

whichever occurs first, to ensure filters performs as stated.

If water has been left sitting in unit for more than 3 days, discard

water and flush out unit.

1. Mix 1 teaspoon bi-carb of soda with 1 - 2L of warm water.

Remove the filter cartridge then pour mixture into filter

bottle. Hold down the cold tap to ensure mixture fills the

cooling tank. Leave for at least 3 hours.

Note: Sanitising Sachet packs are available on 1300 764 325

or www.aquaport.com.au

2. Drain out mixture then flush 2 - 3 L of clean water through

the unit until it has been flushed clean.

Note: Empty tank by unscrewing the drain plug cap at the rear of

the unit. Make sure to drain over a sink, water will immediately

come out upon unscrewing the plug. Completely empty the tank

by tilting the unit back and forth to remove all trapped water.

Continue this process until no more water runs out of the drain.

Press both taps to remove water in taps.

4. Remove filter bottle and wash thoroughly

with warm soapy water.

8 INSTALLATION AND OPERATING INSTRUCTIONS

WARNING: When the filter bottle is removed the Filter bottle O

ring may remain in the top of the water cooler.

Always ensure this piece is correctly seated on the base of the

filtered water chamber prior to installing the filter bottle

otherwise leaking may occur. See figure 1. on page 5.

5. Replace the filter cartridge if necessary.

6. Repeat steps 2 - 12 in the operations instructions.

Do not hesitate to contact our Customer Care Service line

on 1300 764 325 or [email protected]

FILTERED WATER COOLER NOT USED FOR LONG PERIODS

If Signature Filtered Water Cooler will not be used for a long

period of time unplug the unit from the wall socket. Remove

the filter bottle from the unit and clean with warm soapy water.

Empty the water cooler by draining all water from the taps and

via the drain plug and dry the unit.