- ページ 8

ウォーター・ディスペンサー Aquaport AQP-20SILのPDF 据付・取扱説明書をオンラインで閲覧またはダウンロードできます。Aquaport AQP-20SIL 16 ページ。 Signature filtered water cooler

Note: This unit is designed with a wet system. There will always

be a small amount of water left in the unfiltered water chamber

to ensure the filter cartridge doesn't dry out. If the unit is not

used for an extended period of time the water in the unfiltered

water chamber should be discarded and replaced.

9. Once the filtered water chamber (6) is full of water, push the

cold tap (8) down to ensure that water has entered into the

internal water tank. Hold the cold tap down until water runs

out of the tap.

10. Discard water from first refill through taps (and drain plug if

necessary). Discarded water can be used to water a plant.

Tilt the unit back and forth to remove trapped water from

unit. Continue this process until no more water runs out.

11. Repeat steps 8 & 9 then add more water to the unfiltered

water chamber (5) to completely fill the filter bottle.

Note: Water flow rate is dependant on the volume of water in the

filter bottle. For optimum flow rate keep filter bottle full of water.

12. Place lid on top of filter bottle. See page 6/7 for instructions

on how to set the Filter Change Timer.

13. Plug unit into mains power. Switch on power switch (13)

located at back of unit and allow time for the unit to chill the

water.

6 INSTALLATION AND OPERATING INSTRUCTIONS

Note: Once the cooler is switched on the orange power indicator

light (10) will illuminate. When the unit is in cooling mode the

blue cooling indicator light (11) will illuminate, it will turn off

when cooling is complete.

C. SETTING THE FILTER CHANGE TIMER

DOWN

The filter change timer displays the date/ time and number

of days to filter replacement. It should be set every time you

replace the filter cartridge.

DAY COUNTER SET

D/T SET