Aquaport AQP-20SIL Посібник з монтажу та експлуатації - Сторінка 8
Переглянути онлайн або завантажити pdf Посібник з монтажу та експлуатації для Диспенсер для води Aquaport AQP-20SIL. Aquaport AQP-20SIL 16 сторінок. Signature filtered water cooler
Друкувати сторінкуNote: This unit is designed with a wet system. There will always
be a small amount of water left in the unfiltered water chamber
to ensure the filter cartridge doesn't dry out. If the unit is not
used for an extended period of time the water in the unfiltered
water chamber should be discarded and replaced.
9. Once the filtered water chamber (6) is full of water, push the
cold tap (8) down to ensure that water has entered into the
internal water tank. Hold the cold tap down until water runs
out of the tap.
10. Discard water from first refill through taps (and drain plug if
necessary). Discarded water can be used to water a plant.
Tilt the unit back and forth to remove trapped water from
unit. Continue this process until no more water runs out.
11. Repeat steps 8 & 9 then add more water to the unfiltered
water chamber (5) to completely fill the filter bottle.
Note: Water flow rate is dependant on the volume of water in the
filter bottle. For optimum flow rate keep filter bottle full of water.
12. Place lid on top of filter bottle. See page 6/7 for instructions
on how to set the Filter Change Timer.
13. Plug unit into mains power. Switch on power switch (13)
located at back of unit and allow time for the unit to chill the
water.
6 INSTALLATION AND OPERATING INSTRUCTIONS
Note: Once the cooler is switched on the orange power indicator
light (10) will illuminate. When the unit is in cooling mode the
blue cooling indicator light (11) will illuminate, it will turn off
when cooling is complete.
C. SETTING THE FILTER CHANGE TIMER
UP
DOWN
The filter change timer displays the date/ time and number
of days to filter replacement. It should be set every time you
replace the filter cartridge.
DAY COUNTER SET
D/T SET