- ページ 5

ウォーター・ディスペンサー Aquaport AQP-SFS-IHのPDF 据付・取扱説明書をオンラインで閲覧またはダウンロードできます。Aquaport AQP-SFS-IH 12 ページ。 Elite instant boil water cooler hot / cold

A. Elite instant boil water cooler installation for spring

water bottles.

Please follow the instructions below if you are using a spring

water bottle.

Do not turn on the water cooler until the following instructions

have been followed and water is running out of both taps.

1. Vertically insert a spring water bottle into the bottle

supporter on top of the water cooler, the spike will pierce the

bottle cap. You will see bubbles appear inside the bottle, wait

until the bubbling has stopped before dispensing water form

both taps

Note: If you are applying a spring water bottle to the water

cooler for the first time and you do not see any bubbles appear

inside the bottle, open both taps until the bubbling starts and

water flows from both taps. Refer to the trouble shooting guide

for more information.

2. Once the bubbling has stopped, drain 1-2lts of water from

both taps.

Note: The water cooler has been flushed before it left the factory

however we strongly recommend 2-3lts of water is flushed

through the unit before using.

3. Make sure water is running out of both taps then insert the

power plug into the wall socket and turn socket switch on.

The cooler will automatically turn on and have power.

4. This unit is fitted with an instant boil button which is found

at the front of the unit (Red button). When this button is

pressed the water in the hot tank will begin to heat. When

the red instant boil button is pressed the red heating LED

light will turn on. Heating will take approximately 3-5

minutes, when completed the red heating LED light will turn

off. The hot water will reach approximately 90-93°C.

5. The hot water tap has a child safety device installed. To

operate the hot tap you must push the child safety button to

the left before dispensing hot water.

Note: The insulation of the hot tank will be maintained above

50°C up to 1 hour after being heated, however if you require hot

water over 90°C the instant boil button must be pressed.

6. When the unit is turned on for the first time, allow the unit

to cool the water for 1-2 hours before dispensing cold water.

When the unit is cooling the blue LED light will turn off, when

cooling is complete the blue LED light will turn on.

INSTALLATION AND OPERATING INSTRUCTIONS 3