- ページ 5
浄水器 Aquaport AQP-SFKのPDF ユーザーマニュアルをオンラインで閲覧またはダウンロードできます。Aquaport AQP-SFK 12 ページ。 Water filter
ページを印刷するUser's Manual & Warranty
FIttIng and OPeratIng InStrUCtIOnS
Please read this entire guide prior to beginning installation.
The Aquaport water purifier has been designed for quick and simple installation and maintenance.
By carefully reading this instruction manual and following the operational guidelines you will ensure
a successful installation and reliable operation.
Do not use on water that is microbiologically unsafe or of unknown quality. The Aquaport water
purifier is normally installed under a sink or basin, but can also be plumbed-in or wall-mounted. In
all cases you need a pressurised, sterilised and drinkable cold water supply.
Your Aquaport water filter kit is supplied with an installation kit that allows connection to a
dishwasher type cold tap with a 1/2" BSP male thread. If a convenient tap is
not available, you may either have one installed or purchase
the suitable inlet fittings from your supplier.
Before installation the pressure of the water must be tested with the right equipment. If
the pressure of the water is too high or there is water hammer it may damage the system. The
maximum pressure the system should be exposed to is around 125 psi or around 875 kpa. If high
pressure is unavoidable then you may require a pressure reducing valve. Consult your qualified
installer.
MaxIMISIng PerFOrManCe
Set flow rate to 1-3 litres of water per minute.
Flush system for around 5 seconds every time you utilise it
Replace filter cartridges as per instructions following
If filter system has not been utilised for an extended period
flush for at least 1 minute
1.
Mains Connection Piece
2.
Shut-off ball valve
3.
1/4 Tubing
4.
Filter Housing
(Left is Spun Polyproylene Filter)
(Right is Carbon Filter)
5.
Tubing Adaptors
6.
Wall Mount Bracket & Screws
7.
Countertop Tap Assembly