- ページ 11
フードセーバー ChromTech Porvair Miniseal IIのPDF マニュアルをオンラインで閲覧またはダウンロードできます。ChromTech Porvair Miniseal II 20 ページ。
ページを印刷するMethod of Operation
The MiniSeal 2 heat seals microplates by the following method:-
1.
First set the temperature and sealing time of the unit (see page 9)
2.
Next select the correct plate spacers for the plate you want to seal (see page 10 for help
on selecting the correct plate spacers).
3.
Place the unsealed microplate on the top shuttle plate.
4.
Place the cut length of film/foil on the microplate and place the foil loading tool on top of
the foil on the microplate. Ensure that side tab of the foil loading tool is pushed against
the side of the microplate.
Please note: Some sealing material may curl with heat and the foil loading tool will be
required to keep the seal flat before sealing and to prevent the plate from sticking to the
heater block. Two types of foil loading tool are supplied with each MiniSeal 2, one for
normal plates, fig.A, and one for plate with high rims and recessed wells, fig.B).
5.
The sealing process is started by pushing the draw fully in to the unit. Once the draw is
pushed in it will auto latch and the screen will display a sealing message, you may now
release your grip on the handle.
6.
When the seal has finished, the draw will auto open, presenting the plate for removal.
Note: Care MUST be taken when removing the foil loading tool because IT WILL BE HOT.
Always hold it by the specified tab as shown in the photograph below.
Handling tab
(Fig.A)
MiniSeal 2 Issue 1
Handling tab
(Fig.B)