- ページ 2

マルチメーター 3B SCIENTIFIC PHYSICS DT9201AのPDF インストラクションシートをオンラインで閲覧またはダウンロードできます。3B SCIENTIFIC PHYSICS DT9201A 5 ページ。 Digital multimeter

ページを印刷する

The assumption needs to be made that unfore-

seen voltages may be present in the vicinity of

objects being measured (e.g. faulty equipment

or capacitors).

Before using the multimeter, check the

•

housing and measuring leads for damage

and if there should be any malfunctions or

visible damage, the multimeter is not to be

used. Pay specific attention to the insulation

for the measuring sockets.

Be particularly careful when measuring volt-

•

ages in excess of 33 V AC (RMS) or 70 V

DC.

The authorised measuring range is not to be

•

exceeded. If measurements are made when

the magnitude of the variable is unknown,

always select a large measuring range be-

fore shifting down to lower ones.

The multimeter may not be used to make

•

measurement on circuits which exhibit co-

rona discharge (high voltage).

Particular care is to be taken when making

•

measurements on high-frequency circuits

where dangerous voltages may arise due to

superimposition of components.

Make very sure that the voltage value be-

•

tween the measured contact and earth or

between the ground socket and the meas-

urement socket does not exceed 1000 V.

In order to check that the multimeter is ready

•

to use, select the battery test function. Af-

terwards, it is then possible to check that the

voltage source is disconnected and no volt-

age is present.

The multimeter may only be used in a dry,

•

dust-free environment with no risk of explo-

sions occurring.

When measuring current in a circuit, make

•

sure to switch off the power before connect-

ing the multimeter into the circuit.

When making measurements, always con-

•

nect the ground lead first. Disconnect the sig-

nal measurement lead before unplugging the

ground.

When using the measuring leads always

•

hold them with your fingers behind the finger

guard.

To avoid false readings, which may result in

•

electric shocks or injuries, always replace

the battery as soon as the flat battery indica-

+ -

tor (

) is displayed.

Turn off the multimeter before opening the

•

casing, disconnect the power to the circuit

and the measuring leads from the multime-

ter.

Never use the multimeter when its casing is

•

open.

2. Equipment supplied

1 Digital multimeter

1 Pair of measuring probes

1 Battery

1 Instruction manual

3. Symbol legend

Hazard, read instruction sheet

Dangerous voltages

DC voltage

DC current

AC voltage

AC current

Diode and continuity test

hFE

Current amplifying factor of a transistor

Resistance

+ -

Flat battery

CAT

Measuring category as per IEC EN

61010-1

Double insulated casing

EU conformity mark

Earth symbol

┴

Ground symbol

4. Technical data

General specifications

Dimensions:

Weight:

Display:

Operating voltage:

Automatic cut-off:

Fuse:

Connectors:

Measurements/second: 2 – 3 times

Overload display:

Overload protection:

Voltage limits:

Current limits:

2 A range:

20 A range:

90x190x35 mm approx.

310 g approx. (with bat-

tery)

3½-digit LCD,

24 mm, max. 1999

9-V battery, 6F22

After 15 minutes

F2A/250 V

4-mm safety sockets

"1" shown on display

1000 V long-term in all

voltage ranges

max. 2 A

max. 20 A for 10 s with

minimum interval 15

mins