- ページ 7

浄水器 Aquasana AQ-UV-10CのPDF 操作およびインストール手順をオンラインで閲覧またはダウンロードできます。Aquasana AQ-UV-10C 16 ページ。 Whole house uv filter
Aquasana AQ-UV-10C にも：オーナーズマニュアル (20 ページ)

ページを印刷する

To facilitate lamp removal, ensure there is enough space at the lamp connector end

to safely remove the UV lamp and/or quartz sleeve (See Figure 2). The controller

will require a ground fault circuit interrupter (GFCI or GFI) outlet and should be

mounted beside or above the reactor. PLEASE NOTE: All Aquasana UV disinfection

systems are intended for indoor use only as they should not be exposed to the

elements.

Installation

Step 1: The reactor can be installed either

horizontally or vertically using the clamps provided.

Vertical installation is the preferred method with the

inlet at the bottom (lamp connection at the top) as

it allows any air that may be in the lines to be easily

purged from the system.

Step 2: The use of a by-pass assembly is

recommended as it will allow you to isolate the

UV reactor. This will allow for easier access in case

maintenance is required (See Figure 3).

Step 3: Use the supplied fasteners to mount the

UV reactor to wood or drywall. If mounting to an

alternate material you will need to purchase the

proper corresponding fasteners.

Step 4: For water supplies where the maximum

flow rate is unknown, a flow restrictor is

recommended so that the rated flow of your

particular Aquasana system is not exceeded. The

flow restrictor should be installed on the outlet port

of the reactor.

Step 5: It is recommended to have a licensed

plumber connect the UV reactor to the water supply

and may be a requirement depending on where you

are located.

out to hot

& cold water

Figure 3

By-pass assembly

in from

water main

bypass

loop

leave at least

an additonal

reactor length

to facilitate

lamp and sleeve

removal

Figure 2

Lamp Removal Spacing

Note: Installation of your

Aquasana disinfection

systems shall comply with

applicable provincial/

state & local regulations.