- ページ 5

浄水器 Aquasana AQ-UV-10CのPDF 操作およびインストール手順をオンラインで閲覧またはダウンロードできます。Aquasana AQ-UV-10C 16 ページ。 Whole house uv filter
Aquasana AQ-UV-10C にも：オーナーズマニュアル (20 ページ)

ページを印刷する

Before You Begin

The following will be needed for installing the UV system:

Tools

• Pipe cutter, hacksaw or other specialized tools required to cut into your existing

plumbing (e.g. if you have PEX piping)

• Wrench (for tightening fittings)

Other Materials

• Inlet/outlet connections

• Plumber's tape

Water Quality Parameters

UV disinfection is extremely effective against microorganisms but only if the UV

light can pass through the water it needs to treat. This means that the quality of

your water is very important in order to ensure complete disinfection.

Treated water should be tested for at the least the parameters listed below. If

the water exceeds the listed parameters Aquasana strongly recommends that

appropriate pretreatment equipment be installed (equipment required will depend

on parameters being treated):

Manganese (Mn): <0.05 ppm (0.05 mg/L)

Tannins (organics): <0.1 ppm (0.1 mg/L)

UVT (transmittance): >85%

You can have your water tested at a private analytical laboratory or by your local

dealer. It is always recommended to install pre-filtration of at least 5 microns prior

to an Aquasana UV disinfection system.

Hardness: <7 gpg (120 mg/L) – if hardness level is 7 gpg or

slightly below the quartz sleeve must be cleaned

periodically in order to ensure efficient UV

penetration; if above the water must be softened.

Iron (Fe): <0.3 ppm (0.3 mg/L)

Turbidity: < 1 NTU