- ページ 11

浄水器 Aquasana EQ-FE20のPDF オーナーズマニュアルをオンラインで閲覧またはダウンロードできます。Aquasana EQ-FE20 16 ページ。 Whole house water filter iron filter

ページを印刷する

Insert Filters

1. Insert the Pre-Filter into the first housing labeled "Pre-Filter". Insert the

Iron Filter into the housing labeled "Iron-Filter".

NOTE: The notch in the bottom of the housing centers the filter cartridges.

2. Coat the O-rings of both filter housings with the included lubricant.

3. Manually tighten the housings to the

sump caps, and then use the provided

sump wrench to tighten the housings.

Final System Check

Once installation is complete, allow proper time for glue to dry

according to manufacturer instructions. Then, slowly turn on main

water supply. Once system has fully pressurized, inspect for leaks.

After inspecting for leaks, turn on the faucet closest to the

installed unit and allow water to run for 2 minutes for the final

flushing period.

Malfunction

Leaks between housing

sump and housing head.

Leaks in inlet/outlet

connections.

Troubleshooting Guide

Cause

a. Housing not sufficiently

tightened.

b. O-ring affected/old.

a. Not enough sealant

and/or connection not

sufficiently tightened.

b. Improper connection

type.

INSTALLATION STEPS

NOTE: You should only need

to use the wrench for a ⅛ to a

¼ of a turn with the wrench.

Remedy

a. Tighten the housing

further with the wrench.

b. If the housing still leaks,

change the housing's

O-ring with a new one.

a. Remove the previously

applied plumbers tape

and re-apply plumbers'

tape. Tighten the

connection properly.

b. Only use NPT tapered

fittings.