- ページ 4

浄水器 Aquasana OptimH2O AQ-RO-3のPDF オーナーズマニュアルをオンラインで閲覧またはダウンロードできます。Aquasana OptimH2O AQ-RO-3 11 ページ。 Whole house water filter
Aquasana OptimH2O AQ-RO-3 にも：オーナーズマニュアル (14 ページ), オーナーズマニュアル (10 ページ), オーナーズマニュアル (16 ページ)

ページを印刷する

1. Required Tools and Materials

4 — INSTALL RO FAUCET

You will need a sink top hole 1" in diameter. If drilling a new hole, ensure faucet body will

mount flat against surface and that there is sufficient tubing between faucet body and system

manifold. NOTE: Drilling holes into solid surfaces or surfaces made of stone should only be

performed by a qualified and certified installer.

1 Place the black rubber gasket into the groove of the faucet base and feed the tubing and

faucet threads through the countertop hole.

2 Underneath counter, slide on the slotted washer, spacer and nut. Tighten with wrench.

3 Tighten the white quick connector onto the base of the faucet threads.

4 Attach 3/ 8 " white tubing by inserting into quick connector approximately 5/ 8 " until it stops.

Gently tug on the tubing to ensure it is firmly seated in fitting.

NOTE: Do not connect 3⁄8" white tubing from tank to faucet.

gasket

washer

spacer

nut

quick connector

5 — INSTALL RO DRAIN CONNECTOR

WARNING

Be sure that all electrical appliances and

outlets are turned off at the circuit breaker

before working in the cabinet area.

1 Identify drain outlet location. Do NOT install the drain connector onto the same drain pipe

as the garbage disposal whenever possible.

2 Remove protective cover from back of foam seal.

3 Knock center hole out, align holes, and attach to front plate of drain connector.

4 Allowing room for drilling, position the drain connector on sink drain pipe above drain trap.

5 Securely tighten nuts and screws.

6 Using the drain connector port as a drill guide, drill a 7/ 3 2" hole into the drain pipe. Be sure

not to penetrate opposite side of pipe, or to damage side of the drain port fitting.

HOT

COLD

CAUTION

Please wear safety

glasses to protect

eyes when drilling.

Pro Tip

drain pipe

bracket

If there is leakage from the

drain bracket, loosen the bolts

and slide the bracket up so the

drilled hole is at the bottom of

the drain connector port.

new hole