- ページ 15

キッチン家電 Diamond 300のPDF 使用およびメンテナンス・マニュアルをオンラインで閲覧またはダウンロードできます。Diamond 300 16 ページ。 Ce professional slicer
Diamond 300 にも：使用とメンテナンス (10 ページ)

ページを印刷する

6.2.3 - Cleaning the sliceguard

(Fig. n°56)

To remove the sliceguard simply grasp

the hand grip (1) and pull up so that the

two pins unhook (2), and then extract

the sliceguard.

At this point clean the sliceguard with

warm water, the equipped detergent or

with neutral detergent (pH 7).

6.2.4 - Cleaning the sharpener

To clean the sharpener proceed as

follows , Fig. n°57-58:

1. lift (a) the cap up to end of travel;

2. loosen the knob (1);

3. lift (b) the casing (2) and remove (1).

Make sure the knob passes through

the largest opening in the casing (2);

4. rub the grinders with a brush. All

other slicer components must be

cleaned with warm water and the

detergent provided or with a warm

water and neutral detergent (pH 7)

solution.

6.3 - SLIDE GUIDES LUBRICATION

The slide guides on the hopper assem-

bly (1-2) must be lubricated periodically

with the oil (a) provided in the kit (a).

Fig. n°56

(a)

Fig. n°57

Fig. n°58

(a)

Fig. n°59

CHAP. 7 - MAINTENANCE

7.1 - FOREWORD

Before performing any maintenance operation:

a) Disconnect the plug from the mains to isolate the slicer from the mains power

supply.

b) Turn the thickness selection knob to "0".

7.2 - BELT

The belt does not require adjustment. Generally after 3/4 years it must be

replaced. Contact your local "SERVICE CENTRE" for replacement".

7.3 - FEET

The support feet can deteriorate in time and lose their elasticity, causing loss in

stability. To replace contact your local "SERVICE CENTER".

7.4 - POWER SUPPLY CABLE

Periodically check for wear in the power supply cable. If the power supply cable

shows signs of wear or damage contact you local "SERVICE CENTRE" for a

replacement.

7.5 - BLADE

After numerous sharpening and dressing operations check blade diameter. The

diameter must not exceed more than a 10 mm reduction tolerance in respect to

the original diameter. Contact you local "SERVICE CENTRE" for a replacement.

7.6 - GRINDERS

Check that the grinders maintain their abrasive property during sharpening.

Grinders that are no longer abrasive must be replaced to prevent damaging the

blade. Contact you local "SERVICE CENTRE" for a replacement

7.7 - SLIDING GUIDES LUBRICATION

Occasionally put a few drops of oil (from the tube provided) on the round bar the

hopper assembly slides back and forth on, through the hole (OIL) located on the

side of the thickness selection knob.