- ページ 24
ビデオカメラ Panasonic WVNS954 - NETWORK CAMERAのPDF インストレーション・マニュアルをオンラインで閲覧またはダウンロードできます。Panasonic WVNS954 - NETWORK CAMERA 31 ページ。 Ip video cameras
Panasonic WVNS954 - NETWORK CAMERA にも: 仕様 (2 ページ), 取扱説明書 (21 ページ), パンフレット (2 ページ), 参考 (2 ページ), 参考 (2 ページ), 統合ノート (8 ページ), 取扱説明書 (21 ページ)
Initialize the camera
Use the DIP switch to initialize the camera.
The DIP switch can be found when the base unit is
detached. ( page 19)
Important:
The settings including the network settings will be
initialized. Note that the preset position settings will
not be initialized.
Step 1
Detach the camera from the base unit. ( page 19)
Step 2
Set "1" of DIP switch to "ON".
ON
1
2
• The default positions of each DIP switch are OFF.
• Put the protection sheet back into place as it was
after setting to "ON".
Step 3
Attach the camera to the base unit. ( page 17)
Step 4
Turn on the power of the camera. ( page 14)
• When the power LED (green) and the SD memory
card error LED (red) located next to the SD memo-
ry card slot are blinking, the initialization is com-
pleted.
24
DIP switch
ON
1
2
3
4
5
6
3
4
5
6
7
8
LINK
ACT
SD CARD
POWER
Power LED
SD memory card error LED
Step 5
Turn off the power of the camera, and then detach the
camera from the base unit. ( page 19)
Step 6
Set "1" of DIP switch to "OFF".
7
8
Important:
When "1" of DIP switch is in the "ON" position, the
camera will not be operated in normal state. Make
sure that "1" of DIP switch is in the "OFF" position.
Step 7
Attach the camera to the base unit. ( page 17)
Step 8
Turn on the power of the camera. ( page 14)
• When the power of the camera is turned on, the
camera will be operated in normal state.
ON
1
2
3
4
5
6
7
8