Panasonic WVNS954 - NETWORK CAMERA Kurulum Kılavuzu - Sayfa 24

Video Kamera Panasonic WVNS954 - NETWORK CAMERA için çevrimiçi göz atın veya pdf Kurulum Kılavuzu indirin. Panasonic WVNS954 - NETWORK CAMERA 31 sayfaları. Ip video cameras
Ayrıca Panasonic WVNS954 - NETWORK CAMERA için: Teknik Özellikler (2 sayfalar), Kullanım Talimatları Kılavuzu (21 sayfalar), Broşür (2 sayfalar), Referans (2 sayfalar), Referans (2 sayfalar), Entegrasyon Notu (8 sayfalar), Kullanım Talimatları Kılavuzu (21 sayfalar)

Initialize the camera

Use the DIP switch to initialize the camera.

The DIP switch can be found when the base unit is

detached. ( page 19)

Important:

The settings including the network settings will be

initialized. Note that the preset position settings will

not be initialized.

Step 1

Detach the camera from the base unit. ( page 19)

Step 2

Set "1" of DIP switch to "ON".

• The default positions of each DIP switch are OFF.

• Put the protection sheet back into place as it was

after setting to "ON".

Step 3

Attach the camera to the base unit. ( page 17)

Step 4

Turn on the power of the camera. ( page 14)

• When the power LED (green) and the SD memory

card error LED (red) located next to the SD memo-

ry card slot are blinking, the initialization is com-

pleted.

DIP switch

LINK

ACT

SD CARD

POWER

Power LED

SD memory card error LED

Step 5

Turn off the power of the camera, and then detach the

camera from the base unit. ( page 19)

Step 6

Set "1" of DIP switch to "OFF".

Important:

When "1" of DIP switch is in the "ON" position, the

camera will not be operated in normal state. Make

sure that "1" of DIP switch is in the "OFF" position.

Step 7

Attach the camera to the base unit. ( page 17)

Step 8

Turn on the power of the camera. ( page 14)

• When the power of the camera is turned on, the

camera will be operated in normal state.