- ページ 12

インバーター AQUASTREAM ABSC02782のPDF インストレーション、オペレーション＆メンテナンスマニュアルをオンラインで閲覧またはダウンロードできます。AQUASTREAM ABSC02782 20 ページ。

ページを印刷する

Installing the Aquasteam In-Shower Temperature Probe

caution

The R emote Temperature Probe is for use with

Controls only. Do not use any other controls. Do not use any other temperature probe

aquasteam

with the

in-shower controls. Noncompatible products may result in

an inoperative control and a hazardous condition.

caution

Install the

installation and operation instructions. Failure to do so may result in

an inoperative control and a hazardous condition.

1. Determine the location of the R emote Temperature Probe.

The R emote Temperature Probe must be installed:

A. On a vertical surface

B . 4-5 ft. (1.2 - 1.5 m) above the floor

C. Away from the steam head

D. Not exposed to direct steam emis-

sion. The probe has an integral 30 ft.

(9.1 m) cable. Insure that the probe

and/or steam generator are located

accordingly. Contact a

technical service representative if a

longer cable is required.

IMPORTANT:

READ BEFORE LOCATING THE PROBE

DO NOT LOCATE THE PROBE NEAR OR

ABOVE THE STEAMHEAD AS THIS MAY

CAUSE DIRECT STEAM EMISSION TO

INTERFERE WITH STEAMROOM

TEMPERATURE REGULATION.

2. Drill a 5/16 inch (8 mm) diameter hole

in the wall as shown in Diagram 1.

Do not oversize or undersize the hole.

Clean area thoroughly.

3. R emove the knock-out from the

steam generator jacket as shown

in Diagram 2.

4. Insert the remote temperature

probe cable through the knock-out

and connect to the connector

onthe steam generator printed

circuit board marked "TE MP

PR OB E " as shown in Diagram 2.

For illustrative purposes only.

Note:

Consult with qualified designer,

architect or contractor for steam

room construction details.

aquasteam

control according to the

aquasteam

SteamGenerator

(shown with cover removes and NOT installed)

Temperature

Probe

Bad

Steam Head

n c h e s

6 - 1 2 I

c m )

( 1 5 - 3 0

Residential Steambath Generator Systems

aqua s tea m

in-shower controls.

Diagram 1

Printed Circuit

Board Component

shown for

illustrative purpose

Temp Probe

Knock-out

d a

4-5 Feet

(1.2-1.5 m)

Relation of Temperature Probe to Steamhead

Temperature

Sensing Probe

DRAWING NOT TO SCALE

Diagram 2

o G

d o

e B

t s

aquabrass.com