ページを印刷する
PROGRAMMING
1) Disconnect power from the Receiver for 30 seconds.
2) Have the new Transmitter (white) and the Programming Transmitter (black) ready. They
will both be used within a few seconds once power is applied to the Receiver.
3) Apply power to the Receiver (1 beep) and continue to next step within 5 seconds.
4) Press and hold the LOCK button on the Programming Transmitter. Within a few seconds
the Receiver will emit one beep. Let go of the LOCK button and continue to the next step
within 5 seconds.
5) Press the "Lock" button on the new Transmitter. The receiver will emit three beeps to
confirm programming.
6) Repeat step 5 if more than one Transmitter is being programmed.
7) Disconnect the power to the Receiver for a few seconds.
8) Connect power to the Receiver and test new Transmitter function.
ERASE RECEIVER
3) The Receiver's memory can be entirely erased by disconnecting power (30 seconds)
and reconnecting power to the Receiver.
4) Immediately after power is connected, press and hold the UNLOCK button on the
Programming Transmitter until the receiver emit five beeps to confirm complete deletion
of all transmitter programming.
©2016 3Built LLC
Receivers with a "U" in the
part number
(for example: RES12VU, RES6VU-B,
RES12VUE)
Page 5 of 5
6/28/16