水ポンプ Aquatec AquaPro AP6000HMのPDF 取扱説明書をオンラインで閲覧またはダウンロードできます。Aquatec AquaPro AP6000HM 2 ページ。
ページを印刷するIMPORTANT SAFEGUARDS
To guard against injury, basic safety precautions
should be observed including, but not limited to
the following;
• The pump should only be used in clean
water. Do not use the pump in any solvent or
gasoline that is flammable.
• Do not operate the pump without water at
any time, permanent damage may occur.
• Do not operate the pump if the pump or any
of the components of the pump, such as the
power cable, have been damaged.
• The drip loop method should be used to
prevent water from traveling down the cord
onto the plug or power point. If the plug does
get wet, do not unplug the cord. Disconnect
the circuit breaker that supplies power to the
power point. Then unplug and examine the
plug and power point for presence of water. If
the power point has become wet, you should
consult an electrician before using the power
point again.
• Always use a properly grounded power
supply that is connected to an RCD
with a rated residual operating current
not exceeding 30mA. As per AS/NZS
3350.2.41:1997 .
• Always unplug the pump from the power
supply when not in use or before performing
any maintenance on the pump. Never pull
the cord to disconnect the plug from the
power supply. Grasp the plug and pull to
disconnect.
• Do not install or store the pump where
it will be exposed to extreme hot or cold
temperatures.
• Do not cut the cord as this will result in
voiding your warranty.
• Care should be taken to arrange the power
cord so that it cannot be accidently tripped
over or pulled.
• Do not attempt to repair the pump yourself.
Return to an authorized service centre or
place of purchase if a fault occurs.
• Do not use in water above 35°C.
Note: Please consult your retailer for quality original Aquapro replacement parts for your Aquapro
product. Visit www.aquatecequipment.com for nearest stockists.
www.aquatecequipment.com
LIMITED WARRANTY
• Warranty covers only appliance defects and
faulty material and workmanship within a 2
year period.
• Faults arising due to; accidents, misuse,
not following manufacturer's guidelines/
instructions, or power surges/spikes/
brownouts will not be covered.
• The impellor set is a consumable item and is
therefore not covered under warranty.
• Warranty will be void if any tampering,
removal of warranty labels, or electrical
circuitry is evident.
• Warranty will be void if the power cord is cut
or damaged in any way.
• Warranty will be void if any visible signs of
overheating are present.
• Loss of livestock, damage to property or
personal injury caused by this product will
not be covered.
• Warranty claims caused by installation faults
will not be covered.
• It is the customer's responsibility to return
the faulty appliance for any warranty claim,
to Aquatec.
• For any warranty to be valid, an original proof
of purchase must be provided.
• Our goods come with guarantees that
cannot be excluded under the Australian
Consumer Law. You are entitled to a
replacement or refund for a major failure and
for compensation for any other reasonably
foreseeable loss or damage. You are also
entitled to have the goods repaired or
replaced if the goods fail to be of acceptable
quality and the failure does not amount to a
major failure.
MULTI-USE PUMPS
INSTRUCTIONS MANUAL
MANUFACTURED FOR
PO Box 648, Maddington, Western Australia, 6989
Telephone
(08) 9452 2444
Email
www.aquatecequipment.com