Aquatec AquaPro AP6000HM Instruction Manual

Browse online or download pdf Instruction Manual for Water Pump Aquatec AquaPro AP6000HM. Aquatec AquaPro AP6000HM 2 pages.

Print Page

IMPORTANT SAFEGUARDS

To guard against injury, basic safety precautions

should be observed including, but not limited to

the following;

• The pump should only be used in clean

water. Do not use the pump in any solvent or

gasoline that is ﬂammable.

• Do not operate the pump without water at

any time, permanent damage may occur.

• Do not operate the pump if the pump or any

of the components of the pump, such as the

power cable, have been damaged.

• The drip loop method should be used to

prevent water from traveling down the cord

onto the plug or power point. If the plug does

get wet, do not unplug the cord. Disconnect

the circuit breaker that supplies power to the

power point. Then unplug and examine the

plug and power point for presence of water. If

the power point has become wet, you should

consult an electrician before using the power

point again.

• Always use a properly grounded power

supply that is connected to an RCD

with a rated residual operating current

not exceeding 30mA. As per AS/NZS

3350.2.41:1997 .

• Always unplug the pump from the power

supply when not in use or before performing

any maintenance on the pump. Never pull

the cord to disconnect the plug from the

power supply. Grasp the plug and pull to

disconnect.

• Do not install or store the pump where

it will be exposed to extreme hot or cold

temperatures.

• Do not cut the cord as this will result in

voiding your warranty.

• Care should be taken to arrange the power

cord so that it cannot be accidently tripped

over or pulled.

• Do not attempt to repair the pump yourself.

Return to an authorized service centre or

place of purchase if a fault occurs.

• Do not use in water above 35°C.

Note: Please consult your retailer for quality original Aquapro replacement parts for your Aquapro

product. Visit www.aquatecequipment.com for nearest stockists.

www.aquatecequipment.com

LIMITED WARRANTY

• Warranty covers only appliance defects and

faulty material and workmanship within a 2

year period.

• Faults arising due to; accidents, misuse,

not following manufacturer's guidelines/

instructions, or power surges/spikes/

brownouts will not be covered.

• The impellor set is a consumable item and is

therefore not covered under warranty.

• Warranty will be void if any tampering,

removal of warranty labels, or electrical

circuitry is evident.

• Warranty will be void if the power cord is cut

or damaged in any way.

• Warranty will be void if any visible signs of

overheating are present.

• Loss of livestock, damage to property or

personal injury caused by this product will

not be covered.

• Warranty claims caused by installation faults

will not be covered.

• It is the customer's responsibility to return

the faulty appliance for any warranty claim,

to Aquatec.

• For any warranty to be valid, an original proof

of purchase must be provided.

• Our goods come with guarantees that

cannot be excluded under the Australian

Consumer Law. You are entitled to a

replacement or refund for a major failure and

for compensation for any other reasonably

foreseeable loss or damage. You are also

entitled to have the goods repaired or

replaced if the goods fail to be of acceptable

quality and the failure does not amount to a

major failure.

MULTI-USE PUMPS

INSTRUCTIONS MANUAL

MANUFACTURED FOR

PO Box 648, Maddington, Western Australia, 6989

Telephone

(08) 9452 2444

[email protected]