- ページ 5

モニター Aquatel D110のPDF 取扱説明書をオンラインで閲覧またはダウンロードできます。Aquatel D110 12 ページ。 Wireless level monitor
Aquatel D110 にも：取扱説明書 (13 ページ)

setting up tank unit

R emove cap from Tank Unit by turning counter-clockwise and insert batteries.

Check that the Tank Unit is paired with the Display Unit once you have it powered

up. You can check signal strength between units on the Display Unit, there will be

a signal strength bar graph meter at the top right of the LCD screen, ranging from

1 to 4 bars.

test mode

When setting up your Tank Unit, you can set the Tank Unit into Test Mode via the

display so that it sends a new reading every 8 seconds. When in Test Mode, the Tank

Unit's Test Mode LED will be ON (see picture below). When out of Test Mode the LED

will be OFF. Test Mode can be turned on or off via the "System setup" then "Tank Unit

Setup" then select "Configure Tank Unit", scroll to the "Update Interval" and select

Test Mode. Once you have establish that the systems range is ok you can then set an

update interval that suits. The longer the Update Interval the longer the Tank Unit's

batteries will last, for example, when set to update every minute the batteries will last

about 2 months, updating every 10 minutes 20 months and updating every 20 minutes

40 months.

reset button

The D110 Tank Unit comes factory paired to the Display Unit. If the Tank Unit's reset

button is pushed you will need to re-pair it to the Display Unit. See "Pairing Tank Unit"

below.

pairing tank unit

To pair a new T110 or existing Tank Unit enter the "System Setup" by holding the menu

button down for 3 seconds, then select "Tank Unit Setup" and select "Add new tank"

you must within 10 seconds push the reset button on the Tank Unit or you will need

to repeat the process. Once it has found the new Tank Unit, scroll through the setup

options. At any one time there must always be one tank unit paired with the D110

Display, If you are only using the one Tank Unit, then you will need to re-pair it before

you can delete the old Tank Unit location. For further information see

Antenna

Sensor Core

Heat Shield

Pull off to remove

Lid

Twist counter-

clockwise to remove

Tank Unit

Test Mode LED

Reset Button

– 4 –

Antenna

Socket