Aquatel D110 Руководство по эксплуатации - Страница 5
Просмотреть онлайн или скачать pdf Руководство по эксплуатации для Монитор Aquatel D110. Aquatel D110 12 страниц. Wireless level monitor
Также для Aquatel D110: Руководство по эксплуатации (13 страниц)
Печатать страницу
setting up tank unit
5
R emove cap from Tank Unit by turning counter-clockwise and insert batteries.
Check that the Tank Unit is paired with the Display Unit once you have it powered
up. You can check signal strength between units on the Display Unit, there will be
a signal strength bar graph meter at the top right of the LCD screen, ranging from
1 to 4 bars.
test mode
When setting up your Tank Unit, you can set the Tank Unit into Test Mode via the
display so that it sends a new reading every 8 seconds. When in Test Mode, the Tank
Unit's Test Mode LED will be ON (see picture below). When out of Test Mode the LED
will be OFF. Test Mode can be turned on or off via the "System setup" then "Tank Unit
Setup" then select "Configure Tank Unit", scroll to the "Update Interval" and select
Test Mode. Once you have establish that the systems range is ok you can then set an
update interval that suits. The longer the Update Interval the longer the Tank Unit's
batteries will last, for example, when set to update every minute the batteries will last
about 2 months, updating every 10 minutes 20 months and updating every 20 minutes
40 months.
reset button
The D110 Tank Unit comes factory paired to the Display Unit. If the Tank Unit's reset
button is pushed you will need to re-pair it to the Display Unit. See "Pairing Tank Unit"
below.
pairing tank unit
To pair a new T110 or existing Tank Unit enter the "System Setup" by holding the menu
button down for 3 seconds, then select "Tank Unit Setup" and select "Add new tank"
you must within 10 seconds push the reset button on the Tank Unit or you will need
to repeat the process. Once it has found the new Tank Unit, scroll through the setup
options. At any one time there must always be one tank unit paired with the D110
Display, If you are only using the one Tank Unit, then you will need to re-pair it before
you can delete the old Tank Unit location. For further information see
Antenna
Sensor Core
Heat Shield
Pull off to remove
Lid
Twist counter-
clockwise to remove
Tank Unit
Test Mode LED
Reset Button
– 4 –
.
11
Antenna
Socket