- ページ 13

ソウ Diamondback 64683のPDF 取扱説明書と安全上のご注意をオンラインで閲覧またはダウンロードできます。Diamondback 64683 20 ページ。 7" heavy-duty tile saw with sliding table

installing Extension tray

Standing at back of Saw, place the tabs on the

Extension Tray (149) into the corresponding

holes in the Water Tray and push the Extension

Tray down to a horizontal position.

Filling the Water tray

1. Place the Drain Plug into the hole on

the bottom of the Water Tray.

2. Fill the Water Tray with clean water up to

the Maximum Fill Line before every use.

nOticE: Water level must be kept above Minimum

Fill Line at all times during operation or damage

to the Pump and/or Saw Blade will occur.

Workpiece and Work area Set up

1. Designate a work area that is clean and well-lit.

The work area must not allow access by children

or pets to prevent distraction and injury.

2. Route the power cord along a safe route to reach

the work area without creating a tripping hazard or

exposing the power cord to possible damage. The

power cord must reach the work area with enough

extra length to allow free movement while working.

Item 64683

For technical questions, please call 1-888-866-5797.

Water tray

Extension tray installation

Maximum

Minimum

Fill Line

Filling Water tray

3. There must not be objects, such as utility lines,

nearby that will present a hazard while working.

4. Keep workpieces pressed firmly against

the Table and Fence while cutting.

5. Mark cut lines using waterproof marker or crayon.

note: This tool is intended for use on

man-made masonry and tile products only.

Extension

tray

Drain plug

Page 13