- ページ 10

ペットケア製品 EasyPet EP-380RのPDF ユーザーマニュアルをオンラインで閲覧またはダウンロードできます。EasyPet EP-380R 19 ページ。 Easypet rechargeable multi-dog remote training system

Step 4: Match the Receiver with the Transmitter



Turn on both transmitter handset and collar receiver



On the handset, choose a dog channel (A,B or C) for the collar receiver and select a

correction mode and level setting



Press and hold down the power button firmly on the collar receiver



Short press T button on handset to send out a command



The green indicator light on the collar receiver should start flashing on and off



Matching up is done properly, you can release the power button on collar receiver

Collar receiver might have been matched up in to one of the channels on the

transmitter handset when it is tested in factory. To check this, please turn on the

transmitter handset and collar receiver, send a beep tone command to the collar

receiver from A, B or C channel. If the collar receiver bleeps in one of the channels,

the collar receiver has been registered to that channel properly. You do not need to

carry out the following matching-up procedures and can start using the system

through that registered channel.

If the collar receiver does not respond to the transmitter handset in any of the

channels, or if you wish to change the registered channel for this collar receiver,

please follow the matching-up procedures below:

4.1

Switch on the transmitter handset and then choose either A, B, or C dog channel

(Note: this will be your registered channel for the collar receiver). Choose a

correction mode and a correction level setting - any correction mode (static pulse

stimulation, vibration or warning tone) and level can be used for the matching-up, as