- ページ 2

水ポンプ EasyPro ES1250のPDF クイック・スタート・マニュアルをオンラインで閲覧またはダウンロードできます。EasyPro ES1250 4 ページ。 Submersible pump/filter/uv combo

UV Installation and Maintenance

WARNING: Disconnect the unit from power source before performing any maintenance or installation

on the unit.

USE A CLEAN CLOTH TO HANDLE THE UV LAMP, TOUCHING THE LAMP CAN GREATLY REDUCE ITS LIFE

Instructions for replacing and cleaning UV lamp and quartz sleeve. Periodic cleaning of the quartz sleeve may

be necessary for the UV light to reach the bacteria. If the UV lamp is functional and intact, the sleeve may be

replaced or cleaned with a soft cloth and reassembled. After a year of continuous use the lamp may still light

but the UV effectiveness is diminished.

1. Unscrew fountain assembly, then

remove top cover from unit.

4. If the UV lamp is functional and intact,

sleeve may be replaced or cleaned

with a soft cloth and reassembled.

7. Using a clean soft cloth remove the

new lamp from its package and gently

push the lamp into the socket. Do

not touch the UV lamp with your

fingers.

2. Remove three Phillips screws on

pump, pull pump out of base and set

aside.

5. To replace lamp, unscrew threaded

ring that holds the quartz sleeve in,

and remove sleeve from UV assembly.

8. Replace grommet to the end of the

lamp and reinsert into quartz sleeve.

3. Unscrew and remove the large

threaded cap on the UV housing to

reveal inner UV assembly.

6. Remove grommet from end of the

lamp and set aside, gently pull lamp

out of the socket and discard.

9. Reinsert UV assembly into plastic

housing, tighten cap and replace

everything back into base.