- ページ 3

水ポンプ EasyPro ES1250のPDF クイック・スタート・マニュアルをオンラインで閲覧またはダウンロードできます。EasyPro ES1250 4 ページ。 Submersible pump/filter/uv combo

Installation & Operation

WARNING: Disconnect the unit from power

source before performing any maintenance

or installation on the unit.

1. Determine the exact place to install filter. The filter

base must be completely submerged and sit on a

flat level surface.

2. Choose your fountain nozzle and use diagram

below to build fountain assembly and attach to

pump body.

3. Level the fountain assembly using ball-joint.

4. Plug in the pump and adjust diverter valve to

desired fountain spray.

5. Only operate UV unit when the pump is running.

6. If regular beneficial bacteria treatments are used

in the pond, turn the UV unit off for at least 24

hours to allow treatments to be most effective.

Fountain Assembly

Fountain extension tube

Diverter valve with cap or barbed

fitting for optional hose attachment

Maintenance

Refer to previous page for UV lamp and quartz

sleeve replacement. Filter pads and media are

wearable items that may be replaced periodically.

1. Pick up unit out of water and unscrew fountain

assembly. Do not pick up filter by power cord.

2. Remove top cover from unit and take out filter

pads and media.

3. Flush filter pads and media with water or replace.

4. Reassemble filter pads with the correct orientation

and replace top cover.

5. Reattach fountain assembly and return unit to

water.

6. In freezing climates be sure to remove the unit

from the pond and store during the winter.

Ball-joint

Pump extension fitting

Three Tier Nozzle

Two Tier Nozzle

Waterbell Nozzle