EasyPro ES1250 Hızlı Başlangıç Kılavuzu - Sayfa 3
Su Pompası EasyPro ES1250 için çevrimiçi göz atın veya pdf Hızlı Başlangıç Kılavuzu indirin. EasyPro ES1250 4 sayfaları. Submersible pump/filter/uv combo
Installation & Operation
WARNING: Disconnect the unit from power
source before performing any maintenance
or installation on the unit.
1. Determine the exact place to install filter. The filter
base must be completely submerged and sit on a
flat level surface.
2. Choose your fountain nozzle and use diagram
below to build fountain assembly and attach to
pump body.
3. Level the fountain assembly using ball-joint.
4. Plug in the pump and adjust diverter valve to
desired fountain spray.
5. Only operate UV unit when the pump is running.
6. If regular beneficial bacteria treatments are used
in the pond, turn the UV unit off for at least 24
hours to allow treatments to be most effective.
Fountain Assembly
Fountain extension tube
Diverter valve with cap or barbed
fitting for optional hose attachment
Maintenance
Refer to previous page for UV lamp and quartz
sleeve replacement. Filter pads and media are
wearable items that may be replaced periodically.
1. Pick up unit out of water and unscrew fountain
assembly. Do not pick up filter by power cord.
2. Remove top cover from unit and take out filter
pads and media.
3. Flush filter pads and media with water or replace.
4. Reassemble filter pads with the correct orientation
and replace top cover.
5. Reattach fountain assembly and return unit to
water.
6. In freezing climates be sure to remove the unit
from the pond and store during the winter.
Ball-joint
Pump extension fitting
Three Tier Nozzle
Two Tier Nozzle
Waterbell Nozzle