- ページ 4
データロガー Dickson ES120のPDF マニュアルをオンラインで閲覧またはダウンロードできます。Dickson ES120 9 ページ。 Electronic signal data logger
ページを印刷する
Transmitter / Sensor
A powered transmitter is required to operate the ES120/ES120A.Any powered transmitter with a 4-20mA,
0-20mA, 0-5Vdc, 1-5Vdc or 0 to 15v (ES120A) output signal may be used. To connect a transmitter to the
logger, locate the terminal block on the side of the logger. Connect the positive wire of the transmitter to
the positive terminal and the negative wire of the transmitter to the negative terminal of the appropriate
channel. Tighten screws in terminal block to hold in transmitter wires. Repeat steps with second transmitter.
ES120
Typical Setup,
Current (mA)
ES120
Typical Setup,
Voltage (V)
ES120
ES120A
Typical Setup,
Voltage (V)
ES120-A
Rev. 02/06
+
-
Power Supply
+
CH1
-
CH1
+
CH2
-
CH2
+
-
Power Supply
+
CH1
-
CH1
+
CH2
-
CH2
+
-
Power Supply
+
CH1
-
CH1
+
CH2
-
CH2
+
Transmitter 1
-
+
Transmitter 2
-
IN Voltage
Transmitter 1
SIG OUT
GND
IN Voltage
Transmitter 2
SIG OUT
GND
IN Voltage
Transmitter 1
SIG OUT
GND
IN Voltage
Transmitter 2
SIG OUT
GND