- ページ 5

蒸発器 dicodes Dani Extreme V2+のPDF マニュアルをオンラインで閲覧またはダウンロードできます。dicodes Dani Extreme V2+ 12 ページ。
dicodes Dani Extreme V2+ にも：マニュアル (12 ページ)

05 Main Menu (Page 2)

Battery Status

The Check Battery menu shows the battery voltage (Ub0) and the battery voltage under

load during the last puff (UbL). The difference is the voltage drop of the battery. A high

drop (>0.4V) indicates a weak battery or contact problems.

Please note that every battery has an inner resistance and the voltage at its contacts

always drops when current is drained. The more current is drained, the higher the drop

will be.

18650 batteries have inner resistances of about 15mOhm up to 80mOhm. Smaller sized

batteries have even higher resistances. Generally speaking, the batteries with high

capacity have higher inner resistance (e.g. 2500mAh NCR has 75mOhm) and those with

lower capacity have lower inner resistance (e.g. 2100mAh Sony Konion has 15mOhm).

Heater Control (Operation modes)

The mod has 5 operation modes. The default operation is either standard (0, power

setting) or temperature controlled vaping (1). With the "Expert Mode" (Extended

Functions Mod-Menu) enabled, additional operation modes are accessible. They are:

Heater Protection (2); Power Boost (3); and Bypass (4, mechanical mod). With Expert

Mode disabled, menu options 2-4 are unavailable.

0. Standard Mode

In the Standard Mode the wattage selected in the power setting menu is applied to the

coil unless the voltage would be greater than 12V or the current greater than 15A.

For example, for a coil resistance of 4 Ohms and a power setting of 40W, the required

voltage at is 12.7V. With 4 Ohms the maximum wattage is 36W ((12V)²/4R=36W). If the coil

resistance is 0.1 Ohm the maximum power is 22.5W, because (15A)²*0.1Ohm

=22.5W.

With high coil resistance the power is limited by the maximum voltage of 12V and with low

resistances the power is limited by the maximum current of 15A. A power of 40W is

guaranteed from 0.2 to 3.5 Ohms. Resistances of 0.05 to 5 Ohms are possible but with

reduced power.

1. Temperature controlled vaping

This

mode regulates the temperature of the coil to the pre-set value, except i f the power

setting is too low to achieve that temperature. So please adjust the power setting to a

sufficiently high level for when using Temperature Controlled Vaping.

Otherwise if the temperature isn't set high enough the Dani Extreme 2+ switches to a

temperature limitation mode.

When Hctrl is set to 1, the menu directly jumps to the selection of the wire type. Here the

user can select between dicodes-wire (NiFe30), Nickel 200, Titan, Tungsten (Wolfram),

Stainless Steel (Inox) and "Other". With "Other" selected, the temperature coefficient defined

in the Extended Functions Menu under item "Tmp. Cof" is used. The value of the

selected coefficient is displayed under "Wire". For commonly used wires, the predefined

coefficients are: NiFe30=320, Nickel200=620,Titanium=350, Tungsten=440 and Stainless

Steel=105. Note that there are different alloys for Titanium and Stainless Steel on the

market, so the predefined values can deviate from the actual wire-value in use.