- ページ 4

温度コントローラー dicodes Dani Extreme V2+のPDF マニュアルをオンラインで閲覧またはダウンロードできます。dicodes Dani Extreme V2+ 12 ページ。
dicodes Dani Extreme V2+ にも：マニュアル (12 ページ)

ページを印刷する

05 Main Menu (Page 1)

Power Up

Power Up increases the power to the Power-Limit value and then rolls over to 5W.

Power Down decreases the power down to 5W and then rolls over to the Power-Lim

value. The Power-Limit value is adjusted in the Extended Functions Sub-Menu "Heater"

and provides a protection feature for atomizers which are not prepared for high

wattage or to reduce the power range intentionally. The wattage step size is 1 Watt

below 20W and 2W above, but can be set to 0.5W and 1W respectively in the mod-

menu with "Half Watt=1".

With temperature controlled vaping activated, the power setting is the power limit

for the temperature regulator. If the power level is smaller than the value needed to

achieve the selected temperature, the operation changes from a temperature regulator

to a temperature limiter. If the power level is sufficiently high, it sets the heating up

speed of the coil until the set-point temperature is reached.

In the operation mode "Bypass" (mechanical mod), the power setting is not available,

because the power is defined by the battery voltage and coil resistance. The menu

items "Power Up/Down" are not displayed in this case.

Temperature Up and Temperature Down

This Menu items are

selected

selected operation mode. The Temperature Up/Down menu sets the setpoint for the coil

temperature during vaping. The temperature setpoint can be selected from 120°C to

280°C (250°F- 540°F) in steps of 5°C (10°F). To achieve a high precision temperature control,

a correctly performed reference measurement (TempCal Init) is mandatory, see next item.

Manual Coil Temperature Calibration

This Menu item is

Heater Control menu item below). For the use of temperature controlled vaping, the

calibration measurement is a very important part of it. The Temperature calibration

measures the coil resistance at room temperature (20°C) as the reference for

temperature controlled vaping. This together with the wire's temperature coefficient

enables the mod to calculate the coil's temperature.

The calibration must be confirmed in a second step to avoid accidential activation.

After confirmation the display shows "process" until the calibration completed.

It is extremely important to understand, that, if the calibration is performed at a

temperature other than 20°C, the control will regulate a constant temperature, but

with an offset deviation. So take the ambient temperature durcing the temperature

adjustment in to account. Similiar, if a wrong temperatuer coefficient was adjusted, the

actual temperature might deviate dramatically from the set-point (here it is a factor

and not an offset).

Always perofm a caibration, when a new atomizer is attached, even if it is made from

the same coil material

Coil Resistance and Coil Temperature

This is a display only menu item. The coil resistance is displayed in a range from

0.00 to 9.90 Ohms. If temperature controlled vaping is selected, the current measured

coil temperature is also displayed, if not, the display shows T ---.

If the display does not show 20°C even with colled down atomizer, it is recommeded

to perform a manual calibration.

and

Power Down

only available and displayed if temperature controlled vaping is

(see Heater-Control menu item below). So the menu structure adapts to the

only displayed if temperature controlled vaping is selected

(see