- ページ 9

温度コントローラー dicodes Dani Extreme V2+のPDF マニュアルをオンラインで閲覧またはダウンロードできます。dicodes Dani Extreme V2+ 12 ページ。
dicodes Dani Extreme V2+ にも：マニュアル (12 ページ)

ページを印刷する

06 Extended Functions Menu

Additional Explanation to several menu items, page 1

In the following paragraphs, explanations are given for those parameters and items, which are not self

explanatory or which have inter-dependencies with other parameters or functions.

The selection of the correct wire-temperature-coefficient is very important for the

correct operation of the mod, when temperature controlled vaping is selected.

The mod provides predefined coefficients in the main menu for wire types NiFe30

(dicodes wire), Ni200, Titanium, Tungsten (Wolfram) and Stainless Steel (Inox).

If "Other" is selected as wire type, the value of this parameter is used as the

temperature coefficient. The TempCof item in the menu is visible, even if the

operation mode is not selected to temperature controlled vaping.

The Power Limit has an effect on several functions of the mod:

- Power Limit defines the adjustment range of the power in the main menu. As stated

in the main menu already, the limit value sets the roll-over point of the menu items

"Power Up" und "Power Down". The power limitation makes sense especially in the

standard vaping mode and the use of small atomizers or coils, to avoid a coil break.

- Power Limit sets the power during the boost-phase in the Power Boost Mode.

All dicodes devices have a functionality to adjust the minimum discharge level of the

battery between 2.5V and 3.0V (older models 3.5V). Almost all available batteries on

the market specify the minmum discharge level of 2.5V to 2.7V. If the user is unsure,

whether her/his specific battery meets this specification, the level should be set to

2.7V.

The selected voltage is the voltage at the poles of the battery when current is drained

from it (the current drained depends on the power at the coil). In contrast to other

available tube- and box-mods on the market, which stop operation already at 3.4V,

the lower discharge level on dicodes mods lead to a better battery utilization (about

20%).

The time to automatic power off of the mod can be selected between 1 minute up to

60 minutes. We recommend to choose 2 or 5 minutes in conjunction with immediate

vaping enabled ("OnClick"=0). This is the best utilization of the battery. In this

combination, though, there is one situation to be considered: If the mod is transported

in a bag, e.g., and the button is accidentially pressed all the time, it theoretically could

happen that the mod exceeds the maximum vape time, error 7, goes into auto power

off, is immediatle switched on again and so forth in an endless loop.

To overcome this potential problem, the mod has an implemented secure behaviour:

If "OnClicks"<2

the mod can only be switched on again by pressing the button short term 5 times.

This behaviour happens only one time. Afterwards the operation is as selected by the

user. The 5 OnClicks is also activated, when "Onclick"<2

switched off by the user (not auto-power-off).

As indicated, the OnClick range is from 0 (immediate vape) to 5. Note that the mod

is always on after the first click, and then detects whether the selected number of

clicks is performed in a certain time. If this is not the case, it switches off immediately.

Error 7 (TimeOut) happened

AND

the mod has an auto-power-off,

AND

the devices is actively