- ページ 6

モニター Alpha Omega Instruments OXY-SENのPDF 取扱説明書をオンラインで閲覧またはダウンロードできます。Alpha Omega Instruments OXY-SEN 15 ページ。 Oxygen monitor

ALPHA OMEGA INSTRUMENTS CORP.

OXY-SEN OXYGEN MONITOR

Unpacking the Instrument

Upon opening the shipping container, carefully unpack the monitor to check if the outer surfaces

have been damaged. If so, report the findings immediately to Alpha Omega Instruments who will

provide further instructions. If there is no apparent damage, check the contents

to ensure all items were shipped. In some cases, items may be back-ordered.

All damage and shortage claims must be made

known to Alpha Omega Instruments within 10

days after receipt of shipment.

OXY-SEN Oxygen Monitor

Mounting the

The mounting slots for the monitor electronics are 2-5/8" apart vertically, and 5-3/8 " apart

horizontally. The slots can accommodate # 6 through #8 screws.

Powering the OXY-SEN Oxygen Monitor A/C Power Source Version

OXY-SEN Oxygen Monitor

The

ma. MAX. The Oxy-Sen Oxygen Monitor senses the input voltage and adjusts automatically

for proper operation.

Powering the OXY-SEN Oxygen Monitor 24 VDC Power Source Version

The OXY-SEN Oxygen Monitor is powered from a 24 volt DC power source. The unit is

internally fused for 500 mA. All manual references to AC power input do not apply. DO NOT

CONNECT THE 24VDC POWER SOURCE VERSION TO ANY AC (115/220 VAC) POWER

SOURCE!

Oxy-Sen Oxygen Sensor

Mounting the

The pre-cabled sensor mounts into a tapped hole with a M16X1 thread. Insure that only

finger tight pressure is applied to the sensor when mounting, as the o-ring supplied with

the sensor will supply a good seal with finger tight torque to the sensor.

The sensor connects to the monitor's electronics with a pre-wired cable connector,

installed into the connector labeled "Sensor" (use the dimple on the connector for

alignment.

Connecting the Optional Analog Output Cable

When ordered with the optional analog output, the monitor is equipped with a 10 foot (3

meter) cable. This cable can be used to access either the 0-25% or 0-100% oxygen

output range. The location of these connections is shown in Figure 1.0 on page 7.

SECTION 3.0

INSTALLATION PROCEDURES

is powered from 115 VAC/60 HZ. or 208/240 VAC, Hz., at 10

Instruction Manual