- ページ 9

掃除機 Alpha Professional Tools HEPADV10のPDF マニュアルをオンラインで閲覧またはダウンロードできます。Alpha Professional Tools HEPADV10 16 ページ。 Hepa dry vacuum

AboUT THE MACHINE

Insert the hose end into the tank inlet until it clicks. To remove the hose, press the

button on top of the hose inlet, and remove hose.

Insert casters into sockets on bottom of canister. Push casters until seated. Attach

hose to coupling on front of can.

This vacuum cleaner contains no user serviceable parts. If repair is needed, please

take the vacuum cleaner to an authorized Alpha Professional Tools

ter.

Install paper bag on inlet inside of tank. Insert the HEPA filter assembly in the top

of the tank. Install motor head.

for use with power tools drawing 3.9 amps or less. Turn the vacuum switch off, and

connect the power tool drawing 3.9 amps or less to the outlet in the motor head.

When the power tool is started, the vacuum cleaner will start. The vacuum cleaner

will continue to run for a few seconds after the power tool is turned off, in order to

clear dust from the hose. When no power tool is attached, the vacuum cleaner may

also be turned on and off using the switch on the power head.

Coil cord in a large loop and insert under handle for storage. Grasp the plug when

unplugging from wall. Do not pull the cord.

Do not use this vacuum to pick up hazardous materials without HEPA filter being

installed.

Never lubricate the vacuum cleaner motor. The motor bearings are permanently

sealed. This vacuum is intended for indoor or outdoor use and for wet pickup, but

it is not intended to be exposed to rain.

CAUTIoN!

service cen-

9 9