- ページ 4

カメラアクセサリー Axis T93F10のPDF 再塗装の指示をオンラインで閲覧またはダウンロードできます。Axis T93F10 8 ページ。 T93f series outdoor housing

AXIS T93F Housing Series

How to repaint the product

Screw

Arm

Socket

Square nut

Screw (4x)

Ball joint

Preparations

•

If applicable, the equipment must be disassembled according to the instructions in this document.

•

Each part should be stripped from components and crucial parts masked to ensure successful reassembly.

•

All parts to be repainted should be stripped of gaskets, screws, electrical components, connectors and plugs, windows

and domes.

•

All parts to be repainted must be thoroughly cleaned to remove grease, dust or oil.

•

To ensure reassembly and functionality of the product, openings for screws, LED indicators, or microphones must

be masked before painting.

Pretreatment of parts

Depending on the part material and type of paint applied at factory, different pretreatments should be done for the new paint to

adhere as well as possible. For all variants though, proper cleaning to remove oil, grease and dust is strongly recommended.

For more information on the materials used in the product, see its datasheet at www.axis.com

Powder coated parts - Using fine sandpaper, remove the original powder coating down to the stainless steel surface and clean the

parts before painting, or use a primer.

Anodised and chromated parts - Use a primer.

Uncoated stainless steel - No special pretreatment is needed, but make sure that the surface is clean before painting.

Plastic - Use a primer.