- ページ 2

顕微鏡 Olympus BX-FLAのPDF 取扱説明書をオンラインで閲覧またはダウンロードできます。Olympus BX-FLA 46 ページ。 Reflected light fluorescence attachment

ページを印刷する

BX-FLA

This unit employs

a UIS (universal

infinity

system)

optical

design,

and should

be used only with

UIS eyepieces,

objectives,

and condensers.

Less than

optimum

performance

may

result

inappropriate

accessories

are used.

The universal reflected light fluorescence vertical illuminator features interchangeable

cubes to employ excitation

light of different wavelengths.

If also allows combined or alternating reflected light fluorescence

and transmitted

white light observations.

1. Reflected

light fluorescence

+ transmitted

light phase contrast.

2. Reflected light fluorescence

+ transmitted

light Nomarski differential

interference

contrast.

3. Reflected

light fluorescence

+ transmitted

light brightfield

or darkfield.

By mounting standard cubes for reflected light observation, the following observation methods become possible.

1. Reflected

light brightfield/darkfield

observation.

2. Reflected light Nomarski differential

interference

contrast.

3. Reflected

light simple polarized light observation.

This instruction

manual consist of two parts: I. Reflected

Light Fluorescence

Observation

and II. Reflected

Light Observation

Modes. Use these headings to find the relevant page with the instructions

for the particular

observation

mode.

Getting

Ready

I. A vertical illuminator

is delicate. Handle it carefully, and avoid jolts.

2. The high pressure

mercury burner used in the unit should be a USH102 (mfd. by Ushio Electric). The

halogen lamp used in the unit should be a 12V, IOOWHAL halogen bulb (Philips 7724).

3. Verify that the burner is installed correctly and that all cords are properly connected.

4. The ultraviolet rays emitted by the burner are harmful. Be sure to use a UV protective

shield with the unit.

(See page 9.)

5. Do not open the lamp housing while the burner is turned on or for at least 10 minutes after it is turned

off. The lamp housing inside is extremely

hot and will cause injury if touched. (See page 11.)

6. The power supply unit contains high voltage components.

Do not attempt

to disassemble

it.

7. Always ground

the unit.

8. Before opening the lamp housing for replacement

of the burner or other, turn off the main switch and

unplug the power output connector from the power unit. Wait for more than 10 minutes for the burner and

lamp socket to cool down.

9. Before plugging in the mains power cord, make sure that the main switch on the power supply unit is

turned off.

1. Clean all glass components

by wiping gently with gauze. To remove fingerprints

or oil smudges, wipe with

gauze slightly moistened

with a mixture of ether (70%) and alcohol (30%).

A Since solvents

such as ether and alcohol are highly flammable,

they must be handled

carefully.

sure to keep these chemicals

away from open flames or potential

sources of electrical

sparks - for

example,

electrical

equipment

that is being switched

on or off. Also remember

to always use these

chemicals

only in a well-ventilated

room.

2. Do not disassemble

any part of the attachment.

3. The burner has a service life period of 200 hours. When the hour counter on the power supply unit indicates

200 hours, replace the burner with a new one. (See page 8.)

4. When not using the unit, cover it with the dust cover provided and store it in a dry place to prevent mold

formation.

5. If a dichroic mirror cube is not to be used for a while, place it in its container and store it in a safe place.