- ページ 22

顕微鏡 Olympus MX61LのPDF 組立マニュアルをオンラインで閲覧またはダウンロードできます。Olympus MX61L 49 ページ。 200mm/300mm compatible semiconductor/fpd inspection microscopes

ページを印刷する

Fig. 26

Fig. 27

...

Fig. 28

Fig. 29

Attaching the Breath Shield

(MX-BSH or MX-BSH-ESD)

1. Attach the two breath shield mounting brackets @ on the breath

shield ² using the provided screws (shorter ones). For the present,

tighten the screws temporarily using the Allen screwdriver. (If they

are attached completely, it becomes impossible to attach the breath

shield to the microscope frame.)

2. Align the attaching holes | on the mounting brackets with the breath

shield screw holes ³ on the microscope, and clamp using the provided

screws (longer ones).

3. Now tighten the screws that have been secured temporarily in step 1 above.

# Do not tighten the screws excessively to prevent the breath shield

from cracking.

Connecting the Power Cord

!Cables and cords are vulnerable to bend or twist. Do not apply

excessive force to them.

!Make sure that the main switch @ is set to "

connecting cords and cables. (Fig. 27)

!Always use the power cord provided by Olympus. If no power cord is

provided, please select the power cord by referring to the section "PROPER

SELECTION OF THE POWER SUPPLY CORD" at the end of this instruction

manual. If the proper power cord is not used, Olympus can no longer

warrant the electrical safety performance of the equipment.

1. Connect the power cord plug ² to the AC receptacle ³. (Fig. 28)

!Connect the provided power cord correctly and ensure that the

grounding terminal of the power supply and that of the 3-conductor

wall outlet are properly connected. If the equipment is not grounded/

earthed, Olympus can no longer warrant the electrical safety perfor-

mance of the equipment.

2. Connect the power cord plug | to a 3-conductor power outlet ƒ.

Fuse Replacement

1. Always set the main switch @ to "

cord before replacing fuses.

2. When the power cord plug is disconnected from the receptacle on the

microscope frame, the fuse cassette ... becomes visible. (Fig. 28).

3. Apply a flat-blade screwdriver in turn to the claws on both sides of the

fuse cassette to pull the fuse cassette outward.

4. Replace the two fuses and return the fuse cassette to its original position.

Applicable Fuses :

!Use of improper fuse type could result in a fire.

(Fig. 26)

(Figs. 27 to 29)

" (OFF) before

" (OFF) and disconnect the power

T3.15A(H)250V

(LITTELFUSE 2153.15)

(Fig. 29)