- ページ 22

カメラアクセサリー Olympus PFL-E01のPDF 取扱説明書をオンラインで閲覧またはダウンロードできます。Olympus PFL-E01 29 ページ。 Electronic flash waterproof case for the fl-36

Cleaning the case with pure water

After using this case, remove the flash, then

seal it again with the TTL cable still connected,

and rinse it with pure water as soon as

possible. After use in salt water, the case

should be immersed for an extended period of

time in a bowl of pure water to remove any salt

water or salt residues.

CAUTION

：• Water may enter the case under localized high water pressure (such as from a hose.)

Before cleaning the case with water, the flash should be removed.

• Operate the mode dial knob and buttons of the case when it is in clean tap water

to remove any salt from their shafts. Do not disassemble the case for cleaning!

• If the case is dried before all salt has been removed, this could affect its

performance. Always make sure all salt has been removed!

• If the case should be cleaned without the TTL cable connected to it, be sure

to attach the cap to the connector in advance.

After making sure that the case and TTL cable

are free of water drops, loosen the lock dial

screw and disconnect the TTL cable.

CAUTION

：• Do not apply excessive force when disconnecting the cable.

• Be careful not to leave dust or other foreign matter on the connector's O-ring. If

dust or other foreign matter gets on the O-ring, clean it in the same way as the

Case's O-ring.

• After disconnecting the cable, be sure to replace the TTL cable connector

cap on the connector. Before doing so, however, apply a thin layer of the

silicone grease provided with the Case to the threaded section of the TTL

cable connector on the Case.

After washing the case and TTL cable, dry them with a clean, soft, lint-free cloth. Then,

leave them to dry completely in a well-ventilated location protected from direct sunlight.

CAUTION

：• Never use hot air from a hair dryer or other appliance to dry the case and TTL cable,

and never place them in direct sunlight to dry. This could deteriorate or deform the

case, TTL cable and O-ring and lead to water penetration. When wiping the case,

take care not to scratch it.

Lock dial screw

E-20