- ページ 4

ラボラトリー機器 Olympus OMCL-AC160TS-W2のPDF ユーザーマニュアルをオンラインで閲覧またはダウンロードできます。Olympus OMCL-AC160TS-W2 4 ページ。 Micro cantilever

When you set your samples to your instrument, please consider the unique shape of the

tetrahedral tip, that is 'good symmetry', when viewing from its front side and choose the

direction of the sample. When measuring long grooves, you can get an idea of what angle of

the cut will be quickly by aligning the cantilever along the grooves and scanning across at

right angles against grooves (see below).

- 7e -

Trouble-shooting Guide

Situations as described below may arise when using this type of cantilever.

Case: In adjusting the sensor optics before scanning, the movement of the reflection spot on

the photo detector is critical so that the sensor optics is hard to adjust to zero position.

When the sensor illumination spot on the cantilever is not small enough and is positioned

at the triangular part of the cantilever, unexpected reflection and light scattering occur.

This may cause the unexpected movement of the reflection spot on the photo detector.

Solution:

Try to adjust the focus of the sensor optics again and move the spot position a little

opposite to the free end of the cantilever.

Information

Please contact following if you have any question on this user's manual.

OLYMPUS CORPORATION

Microtechnology R&D Division

2-3 Kuboyama-cho Hachioji-shi Tokyo 192-8512 Japan

Please access to the web page of OLYMPUS micro cantilevers.

http://www.olympus.co.jp/probe

Ver. 4.0 Sep. 18, 2009

OLYMPUS CORPORATION

- 8e -