- ページ 11

ソウ Axminster TS-200のPDF 取扱説明書＆パーツリストをオンラインで閲覧またはダウンロードできます。Axminster TS-200 17 ページ。 200mm table saw

Malfunctions

Machine vibrates:

Cuts are not clean/wood is burned:

Rapid sawing tool wear:

Motor becomes too warm: (It is too hot to touch with bare hands, it continuously shuts itself off.)

Machine comes to a stop:

Wood is raised by the rear side of the saw blade:

The spindle height is difficult to adjust:

Miscellaneous:

--Clamping levers for height and diagonal adjustment are not tightly screwed.

---Sawing tool is not tightly screw.

---Sawing tool is dull

---Sawing tool is incorrectly mounted.

---Sawing tool is incorrectly sharpened.

---Contaminated wood(cement, sand , nails).

---By all means have a qualified electrician inspect the motor.

---Overloading (feeding too rapid, Sawing tool is dull).

---Longitudinal limit stops are not parallel

---Splitting wedge is not aligned or crossing is too weak

---Thoroughly clean and lubricate the threaded rod, gears and slide tracks.

---Check the operation of the clamping lever.

--- Bearings make unusual noises: Inspect the bearings and replace if necessary.

----Check the tension of the V-belt (V-belts are accessible when the exhaust cover

is removed).