- ページ 7

旋盤 Axminster Engineer SeriesのPDF 取扱説明書をオンラインで閲覧またはダウンロードできます。Axminster Engineer Series 20 ページ。 Pillar drill
Axminster Engineer Series にも：オリジナル取扱説明書 (16 ページ), オリジナル取扱説明書 (16 ページ), オリジナル取扱説明書 (19 ページ), オリジナル取扱説明書 (18 ページ)

Operation

1. Before starts to use this machine, operator should go through the instructions carefully

so as to acquaint with the construction of the machines, the functions of the various

controls and also the driving systems.

2. This machine uses touching button (see operation panel below), operating steps refer

to the flow chart.

Spindle speed readout

Operation panel

Operating steps

1. Insert the electric plug into its socket. Then release the emergency stop switch by

turning the red round head of the switch. you can see the spindle speed readout will

bright, it means power on.

2. Press 'Start' button (the green and oval button is "I") on the touching panel, spindle

speed readout shows '0100 FORWARD'. These showing on the display's right side.

Notice:'0100' is the lowest speed of this machine.

3. You can choose press the ' ' button or ' ' button, if press the ' ' button the spindle

will rotate "Forward", if press the ' ' button the spindle will rotate "Reverse".

4. Press the '+' button the spindle speed will quicken, you have two choice: one is single

click then the speed rise 10 rpm one click, the other is press the "+" button not loosen

then the speed will rise quickly, the highest speed is 2000 rpm. Also you can press the

"-" button the spindle speed will slowly, you also have two choice the control method as

Spindle depth readout