Axminster Engineer Series Kullanım Kılavuzu - Sayfa 7

Torna Tezgahı Axminster Engineer Series için çevrimiçi göz atın veya pdf Kullanım Kılavuzu indirin. Axminster Engineer Series 20 sayfaları. Pillar drill
Ayrıca Axminster Engineer Series için: Orijinal Talimat Kılavuzu (16 sayfalar), Orijinal Talimat Kılavuzu (16 sayfalar), Orijinal Talimat Kılavuzu (19 sayfalar), Orijinal Talimat Kılavuzu (18 sayfalar)

Axminster Engineer Series Kullanım Kılavuzu
Operation
1. Before starts to use this machine, operator should go through the instructions carefully
so as to acquaint with the construction of the machines, the functions of the various
controls and also the driving systems.
2. This machine uses touching button (see operation panel below), operating steps refer
to the flow chart.
Spindle speed readout
Operation panel
Operating steps
1. Insert the electric plug into its socket. Then release the emergency stop switch by
turning the red round head of the switch. you can see the spindle speed readout will
bright, it means power on.
2. Press 'Start' button (the green and oval button is "I") on the touching panel, spindle
speed readout shows '0100 FORWARD'. These showing on the display's right side.
Notice:'0100' is the lowest speed of this machine.
3. You can choose press the ' ' button or ' ' button, if press the ' ' button the spindle
will rotate "Forward", if press the ' ' button the spindle will rotate "Reverse".
4. Press the '+' button the spindle speed will quicken, you have two choice: one is single
click then the speed rise 10 rpm one click, the other is press the "+" button not loosen
then the speed will rise quickly, the highest speed is 2000 rpm. Also you can press the
"-" button the spindle speed will slowly, you also have two choice the control method as
Spindle depth readout
6