- ページ 15

ツール Axminster ujk 106843のPDF マニュアルをオンラインで閲覧またはダウンロードできます。Axminster ujk 106843 20 ページ。 Universal dovetail jig

• Max timber width - 300mm

• Min timber thickness - 6mm

• Max timber thickness - 25mm

Parts needed -

• Template A (through / box)

• 12.5mm Straight cutter

• ¾" (19mm) Guide bush

All boards are cut vertically

1) Attach comb A with the straight fingers at the front of

the jig, see fig 01 & level the comb by placing a 15-20mm

thick, 150mm - 200mm x 200mm - 250mm flat board

underneath the comb locking the comb in place using

the comb lock knobs, see fig 02.

Fig 01-02

2) Remove the magnetic extraction then use the hex

key provided to move the side stop to the left. Load in

vertically the first board on the left of the jig pushing

up to the underside of the comb & centralised to the

fingers, see fig 03-04-05-06.

Fig 03-04-05-06

3) Undo the comb lock knobs & use the comb adjuster

knobs to ensure that the two finger lines on the comb

are centralized to the top of the board & look equal along

the length, see fig 07-08-09.

Fig 07-08-09

4) Slide the side stop to the right to make contact with

the side of the material, see fig 10 & lock in place.

Fig 10

5) Use the opposing board to mark a cutter depth set line

on the material then plunge the cutter down through

the fingers in front of the material so that the tip of the

cutter just meets the marked line, see fig 11-12-13.

BOX / FINGER JOINTS

Equal distance

Continues over...

Side Stop