- ページ 16

ツール Axminster ujk 106843のPDF マニュアルをオンラインで閲覧またはダウンロードできます。Axminster ujk 106843 20 ページ。 Universal dovetail jig

BOX / FINGER JOINTS

Fig 11-12-13

6) Slide or reattach the extraction & begin the cut

working from left to right ensuring that the router stays

flat on the comb at all times, see fig 14. Use the guide

comb lines to help find the fingers, see fig 15. DO NOT

LIFT THE ROUTER WHILST IT IS RUNNING!

Fig 14-15

NB If working in very hard wood a half depth cut may

be required.

7) The opposing cut is done on the right hand side of

the jig & uses the fingers just cut to set up. Firstly undo

the side stop & slide it to the right. Then push the precut

fingers fully up through the comb & centralise using the

smaller part of the set gauge (H) provided and lock in

place, see fig 16-17-18-19-20.

Fig 16-17-18-19-20

8) Slide side stop to the left to make contact with the

board & lock in place. Remove the set up board & replace

with the board to be cut, sliding it in against the side

stop & up against the underside of the fingers, see fig

21-22.

Fig 21-22

9) As before, use the opposing board to mark a cutter

depth set line on the material then plunge the cutter

down through the fingers in front of the material so

that the tip of the cutter just meets the marked line,

see fig 23. NB If using different thickness boards the

cutter depth will need to be reset, if the board thickness

is the same then the cutter depth remains the same as

the previous cut board.

Fig 23