- ページ 2

チューナー Arcam Alpha 7のPDF ハンドブックをオンラインで閲覧またはダウンロードできます。Arcam Alpha 7 8 ページ。 Arcam tuner handbook
Arcam Alpha 7 にも：ハンドブック (8 ページ), ハンドブック (12 ページ), ハンドブック (8 ページ), サービスマニュアル (17 ページ), ハンドブック (11 ページ)

Section A

Installation

CONNECTING TO A POWER SUPPLY

WRONG

PLUG ?

If the plug supplied with the tuner does not fit your power

supply, see the inside back cover of this handbook for guidelines on

changing a plug, or contact your dealer to obtain a suitable power

cord.

Check that your mains supply voltage agrees with the voltage

setting indicated on the rear panel of the 1) tuner.

If your mains supply voltage is different, consult your Arcam dealer or

Arcam Customer Support on 01223 203203.

PLUGGING

Push the plug (IEC line socket) of the cable supplied with the tuner

into the socket (POWER INLET) in the back of the tuner,

Make sure it is pushed in firmly

IEC LINE SOCKET

Push the plug on other end of the cable into your power supply

socket.

The tuner is double insulated and does not require an earth.

This is why there is no centre (Earth) pin in the socket (POWER

INLET)

CONNECTING TO OTHER EQUIPMENT

All the sockets carrying messages te other hi-fi equipment (output

channels) are colour coded for identification.

The use of high quality interconnect cables to and from other hi-fi

equipment is recommended to ensure the best sound quality (sonic

performance).

Interconnect cables are not supplied with these tuners.

The left channel sockets are marked L.

The right channel sockets are marked R.

CONNECTING YOUR TUNER TO YOUR AMPLIFIER

AUDIO OUTPUTS

There are two pairs of identical outputs provided. Connect

one of these to your amplifier's tuner input using a suitable

interconnect cable. Insert the red phono plug into the

socket labelled 'R' for Right and the other phono plug into

the socket labelled 'L for Left.

The second set of audio outputs can be used to connect to

a second amplifier set up for 'multi room' use or routed to

a tape recorder for 'off air' recording.