- ページ 4
チューナー Arcam Alpha 7のPDF ハンドブックをオンラインで閲覧またはダウンロードできます。Arcam Alpha 7 8 ページ。 Arcam tuner handbook
Arcam Alpha 7 にも： ハンドブック (8 ページ), ハンドブック (12 ページ), ハンドブック (8 ページ), サービスマニュアル (17 ページ), ハンドブック (11 ページ)
ページを印刷する
Section C
Using the tuner
TUNE
|
|
@.@Press to tune up or down through the chosen frequency
band.When pressed continuously, the selector will scroll
continuously, when touched and released, the selector wili
scroll in fixed amounts.
ON TUNE INDICATOR
©
This will glow green when you are correctly tuned to a
signal on any band. When you are off tune the indicator will
be off.
BAND
10) Selects FM, AM (MW) or LW frequency band,
The appropriate letters appear on the display.
The MW band is denoted by AM on the display.
MONO
&
Selects mono or stereo output.
Stereo in only available on FM radio stations.
The word MONO or STEREO will light on the display.
If a weak station is received in stereo the background hiss
can be reduced (and in most cases eliminated) by selecting
MONO.
AUTO
®
When pressed, the word AUTO will illuminate in the display,
When buttons O
Or pressed the tuner will stop
automatically at a station with any suitably strong signal.
To continue searching press Oo
again.
STORING RADIO STATIONS
FM 'level' where
16 stations can be stored.
AM 'level' where 8 stations can be stored.
The 8 stations can be either MWLW
or a combination of the two.
You move up or down the levels by pressing the BAND O
button, which scrolls through the levels.
Your first and ninth FM stations are stored using button 1-9, your
second and tenth FM stations are stored using button 2-10 and so
on.
TO STORE
A RADIO
STATION
IN THE MEMORY
Select the BAND, (FM, AM or LW) using button ® and tune into
the radio station you wish to store.
Press the STORE button
You will see PI in the display at (D.
Within 5 seconds, press the memory button (numbers | to 8) you
wish to store the station under.
The station is stored when a number appears in the right hand
end of the display at OD.
To store stations 9-16 in FM, proceed as above but press the
STORE button ® twice,
You will see P2 in the display at @.
This will access the buttons 9-16,
TO SELECT A STORED
RADIO
STATION
Select the BAND, FM, AM or LW using button QD.
To select stations stored on presets |-9, press the memory button
number which stores the station you wish to select, for a 'split
second? only.
To select stations 9-16 in FM, proceed as above, but
press the memory button number which stores the station
you wish to select, for a 'whole second".
POWER
®
Switches the unit on and off.
POWER
INDICATOR
This will glow green to show that the unit is switched on.
PRESET INDICATOR
Indicates the number of the preset currently selected.
FREQUENCY
DISPLAY
Indicates the frequency of the selected station in MHz (FM)
or kHz (AM).
PRESET MEMORY
BACK-UP
The preset memory will be retained while the tuner is
connected to the mains. If the mains supply is disconnected,
the memory will be retained for approximately one week.
RADIO
INTERFERENCE
Alpha 7/8 Tuners are audio devices containing microprocessors,
and other digital electronics.
They have been designed to very high
standards of electromagnetic compatibility.
EC COUNTRIES
This product has been designed to comply with directive
89/336/EEC.
USA
This product complies with FCC requirements. If the equipment
causes interference to radio/television reception, which can be
determined by switching the equipment off and on, the following
measures should be taken: Re-orientate the receiving antenna or
route the antenna cable of the receiver as far as possible from this
appliance and its cabling. Relocate the receiver with respect to this
appliance. Connect the receiver and this appliance to different
mains power outlets. If the problem persists contact your Arcam
dealer or Arcam Customer Support on +44 (0) 1223 203203.
SAFETY STANDARD
This product has been designed to meet the IEC 60065
international electrical safety standard.